Other Parts Discussed in Thread: AWR2243, 我在官方AM2732+2*AWR2243两片级联的Demo中导入了以太网模块，使能了CPSW，添加了PHY驱动以及LWIP协议栈。目前通过.map文件看下来，添加以太网模块前后MSS_L2空间占用 ...

We have successfully interfaced the LDC5072-Q1 inductive position sensor with the metallic (Aluminium) target and as suggested by the In LDC5072_Sensor_Designer software, we followed the steps to get ...

I have collected data activating all 12 Tx and 16 Rx. I read all the bin files (master and slaves) using fread(fid, 'int16'). Total number of samples are correct as per the set parameters. Total ...

If you are wanting to configure a peripheral register as a DMA source or destination address, you want to use the "Manual" or "Variable/Function Name" options. Please see the explanation on the thread ...

I can't download my firmware(.out) to CC2745R10 EVB with LP-XDS110 download debugger.(I chose Part number:CC2745P10 because there is no CC2745R10.) Here is a my trouble shooting. 1. Hardware Setup Set ...

Any functional roll-off as you approach the 'max ambient' thresholds shown in Figs 8-5, 8-8, 8-11? In short, would we expect to see any reduction in efficiency, maximum available current draw, or any ...

It seems both Windows (192kHz max?) and Linux (ALSA: 384kHz) have maximum hardware audio capture sampling rates below 768kHz. When a sound recording application like Audacity is asked to capture at ...

sdhci_send_command: MMC: 1 busy timeout increasing to: 200 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 400 ms. sdhci_send_command: MMC: 1 busy timeout increasing to: 800 ms.

This is my encoding channel, the code stream encoded by this channel, the general_level_idc value is 10, but this value does not comply with the h265 protocol, the decoder cannot decode correctly, how ...

So at this point, we are trying to use MCU to overwrite the current and clear the Dead Battery Mode. Could you help to support: 1. Which register to over write the charging current? Is that possible ...

We can't pull a video stream from the camera right now,We want to read the register to confirm the csirx status,Which register should we read? Can you provide a read instruction?

The ADS1248 is only specified to 105C, so it is possible you are getting issues because you are nearing (or exceeding) this rating. What exactly are the issues? Can you describe them in more detail, ...