Order of millivolts output swing to be fed into an ADC I'm using currently using TINA-TI to simulate the TIA, with the ultimate goal of producing a tangible physical version of the circuit in the ...

I designed an AC/DC converter using TIDRF62 as a reference. The TIDRF62 uses Wuerth 750314727 however one was not available when I made my design and I used a Myrra 74080. The main difference between ...

Hello, my device is of HSSE type. R5 was previously developed under version mcu_plus_sdk_am62x_08_06_00_18. The compiled firmware will finally be signed by the ...

I modified the configuration of a customer board based on the AM62x-evm, and the image and sdk can be successfully compiled through the command. $ MACHINE=am62xx-customer bitbake tisdk-customer-image ...

I need to operate a 4x4 matrix to find its inverse in my firmware. I was trying to see if there was a function from any TI library can be used for that. So far, I haven't found any. 1. Please confirm ...

Here is what we want to achieve when evaluate on TI EVM. We have an application running on Linux A53 core and we want to update it each time we power on the EVM. Using EMMC boot media of EVM, after ...

I m trying to connect LP-MSPM0G3507 eval board by using xds110-et on board debugger but when i connect to board to pc , i m getting this error attached ...

I am looking for a device that will convert a monochrome RS-170 (NTSC) video signal from a camera into the "standard" LCD interface. In other words, RS-170 will be input into the device and 8-bit RGB ...

The difference between case 1 and case 2 with open circuit output lies in whether the output capacitance is large or small. How to determine whether the output capacitance is large or small, and is ...

we use the LM5164 chip on many electronic boards and we are very satisfied. I noticed that typically the impedance of the VIN pin (referred to the GND pin) is around 9MΩ. The measurement is made with ...

My customer is using an MCU as host of CC2642 to download image to it. In a particular case, for example CC2642 flash is not empty but ROM bootloader is not enabled, the MCU cannot access the ROM ...

The IIC Buck Boost raises the battery voltage to between 0 and 20+V (in steps) and then supplies it to a push-pull stage. This stage, through transformer isolation, boosts the voltage to between 0 and ...